Carrier Ultima 53 Manual
First of all you need to find a new garage that isn't just telling you what they don't know. If it were just a filter they would have replaced it and watched you drive away with a smile on your face.
Carrier Ultima 53 Manual
There is nothing better than a happy customer. The other thing is that you don't mention if the. is a manual or automatic. The.
could be a bunch of different problems depending on type of. Also Volkswagen's are noted for many sensor problems. There are many sensors that can throw a code if they even malfunction for a second. Wish I could help more, but the information is to vague. Apr 25, 2012.
Hi Amanda: Check this on 2000 Acura TL 3.2L MFI SOHC 6cyl. 1: Typical starter mounting (zoom image link ) Fig. 2: Exploded view of the alternator mounting - 3.5L shown, 3.2L similar (zoom image link ) Fig. 3: To remove the belt from the pulley, remove the lower mounting bolt, adjusting lock bolt and adjusting rod (zoom image link ) Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer. Thank you for using FixYa, have a nice day. Nov 30, 2011.
That work should ONLY be done by a Drive Shaft Specialty Shop,that repairs & balances lots of things,not just driveshafts I will agree with you, as I don't know But a dealer will sell you the whole deal, so I never recommend them for even a car wash There may be,just saying,don't know, a very few that can't be repaired. I would pick it up & personally take it to a driveshaft shop & not pay anything for that part of the work agreed to. I never had those issues when i had my trans shop, because I followed my rules & I was a machinist before, so there isn't much I can't do Flywheel,Clutch &Driveshaft Balancing & tire mounting I personally take out of shop & stand by to see the work getting done. May 28, 2011. 4.3L Engine.
Remove or disconnect the following: Negative battery cable Bracket and shield Wires Mounting bolts and shims Starter To install:. Install or connect the following: Starter Mounting bolts and shim. Torque the bolts to 33 ft lbs. Torque battery wire nut to 89 inch lbs.
(10 Nm) and ignition nut to 18 inch lbs. Bracket and shield. Torque the nuts to 53 inch lbs. Negative battery cable Fig. Exploded view of the starter motor-4.3L engines. Remove or disconnect the following: Negative battery cable Bracket and shield Wires Mounting bolts and shims Starter To install: Install or connect the following: Starter Mounting bolts and shim. Torque the bolts to 33 ft lbs.
Torque battery wire nut to 89 inch lbs. (10 Nm) and ignition nut to 18 inch lbs.
Bracket and shield. Torque the nuts to 53 inch lbs.
Negative battery cable Fig. Exploded view of the starter motor-4.3L engines. Hope help with this (remember rated and comment this). Mar 17, 2010. Removal.
Remove or disconnect the following: Negative battery cable Radiator mounting bolts, 1.6L only Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator Fig. Exploded view of the alternator-XG 300 and XG 350 Removal & Installation. Remove or disconnect the following: Negative battery cable Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator Fig. Exploded view of the alternator-XG 300 and XG 350. Before servicing the vehicle, refer to the Precautions section.
Remove or disconnect the following: Negative battery cable Radiator mounting bolts, 1.6L only Alternator drive belt Alternator wiring harness connectors Alternator. It may be necessary to raise the radiator Fig.
Exploded view of the alternator-XG 300 Fig. Exploded view of the alternator-XG 350. Install or connect the following: Alternator and reposition the radiator, if raised Alternator wiring harness connectors Alternator drive belt.
Adjust the alternator belt and torque the bolts to the following specifications:. Accent: Pivot bolt to 14-18 ft. (19-25 Nm) and adjustment bolt to 14-20 ft. 2.0L and 2.5L Sonata, Elantra and Tiburon: Pivot bolt to 14-18 ft. (19-25 Nm) and adjustment bolt to 105-132 inch lbs.
2.4L Sonata: Pivot bolt to 26-41 ft. (34-54 Nm) and the adjustment bolt to 14-18 ft. 3.0L Sonata and XG 300: Pivot bolt to 14-18 ft.
(19-25 Nm) and adjustment bolt to 11-16 ft. Install the radiator mounting bolts, if removed. Connect the negative battery cable.
I hope hrlp you with this. Good luck and remember rated this help- Aug 25, 2009.